Call an expert today: +44 (0)114 272 2270


Innovate UK logo
What is MultiMEMS?

MultiMEMS is a novel micro-technology platform for the nutrient sensing. It will open up the continuous monitoring of nutrients such as phosphates, nitrates to new applications. It will give essential observability – which is currently absent in monitoring the increasing problem of nutrients in our rivers and other natural waters.

The new sensor platform is based on the coupling of polymeric compounds with affinity toward target substances with microelectromechanical mass sensing technologies.

The technology is low cost and comparable with those used for continuously measured parameters such as pH, DO and conductivity. Additionally, the probes will measure multiple parameters.

Why is it needed?

The increasing problem of nutrients and pesticides in our natural waters, and the state of the art in monitoring these substances, mean a step change is required.

The imparting of nutrients on the aquatic environment is arguably our biggest impact? from agrirunoff (59% of nitrates, 26% of phosphates) and from wastewater treatment works outfall.

Nitrate Vulnerable Zones (NVZ) are areas of land that drain into nitrate polluted waters, or waters which could become polluted by nitrates. The extent of nitrate vulnerable zones has increased dramatically in recent years.

Around 50% of the total river length in England and Wales has a phosphate concentration greater than 0.1 mg/l. This is the limit observed to say whether water is fit for treatment for potable water.

Nutrients are very difficult to measure in the field. Spot sampling using colorimetry and the like gives a small amount of expensive data, as does autosampling and relaying for laboratory analysis. Obviously, there is latency in the data provided by this latter approach.

ISE (ionselective electrode) sensors are high maintenance, expensive and give very poor, unreliable data, but are available for ammonium, nitrate and chloride. Some process instruments are available, which use reactions and reagents, at a cost in the order of tens of thousands of pounds.

How does it work?

MultiMEMS is an integration of current technologies:

  • Polymers engineered to bind only specific substances: affinity layers
  • Mass sensing – Micro electromechanical structures sense tiny accumulated masses, down to 1µg/cm2 of contact area
  • Signal processing – deducing concentrations of target substances from MEMS structure resonant responses

The MultiMEMS probes will be integratable using industry standard protocols. This will allow this powerful new technology to leverage contemporary logging and communications technology and on-line platforms.

Why is it different?

MultiMEMS will allow continuous accurate measurement of a range of substances, starting with phosphates, nitrates and metaldehyde. This will be at a cost comparable to that for other commonly measured variables. This is without resorting to physical samples and laboratory analysis, or the expensive and limited-observability approach of spot sampling.

Devices will be unattended and will measure a series of difficult-to-measure parameters. In short, MultiMEMS will the economic observation of natural waters at a detailed temporal level. This will start to allow the problems created by agricultural runoff and wastewater outfalls to be addressed, and for problems to be addressed further up the chain.

Project Partners

Environmental Monitoring Solutions Ltd (Project Lead) – Project management, market engagement and exploitation, guiding the practical design of instruments, and field trials

University of Sheffield and particularly the Kroto Institute – Affinity chemistry, surface chemistry, mechanical MEMS design

Practical Control Ltd – Signal processing and production of the probe and associated software

Accreditations & Awards

Achilles UVDB Qualified logo
citb logo
Institute of Leadership and Management logo
Chamber Buisness Awards logo
Sheffield Business Awards logo
Safe Contractor logo
Nebosh Accredited Centre 934 logo
Sheffield Chamber of Commerce Member logo

Related Insights

Flood resilience – is your business at risk and do you have a plan?

Flood resilience – is your business at risk and do you have a plan?

This blog discusses about effective business flood plans and how you can protect your business with one in place.

EMS Acquires Envirocare and Appoints John Healey as MD

EMS Acquires Envirocare and Appoints John Healey as MD

Environmental Monitoring Solutions Ltd (EMS) is excited to announce the acquisition of Envirocare, a Bradford based emissions monitoring and occupational hygiene consultancy.

Reduce your annual energy costs through the ETL & ECA Scheme

Reduce your annual energy costs through the ETL & ECA Scheme

This blog discusses ways to reduce your annual energy costs through the ETL and ECA Scheme.

Want to know more?

To discuss MultiMEMS and our other Sensing Technologies, please contact Sonja our Innovation Consultant.

© 2021 Environment Monitoring Solutions Ltd